Philips Electric Shaver T 5000 User Manual

FULL TWO YEAR WARRANTY  
8. Dispose of used batteries properly. Do not incinerate.  
Batteries may explode if overheated. Do not wrap in metal  
or aluminum foil. Wrap in newspaper before discarding. It  
is suggested that you contact your local town/city to deter-  
mine proper battery redemption site(s) in your area.  
IMPORTANT  
SAFETY  
Philips Electronics North America Corporation warrants each new  
Norelco product, Model T-5000 (except cutters), against defects in  
materials or workmanship for a period of two years from the date of  
purchase, and agrees to repair or replace any defective product with-  
out charge.  
IMPORTANT: This warranty does not cover damage resulting from  
accident, misuse or abuse, lack of reasonable care, the affixing of any  
attachment not provided with the product or loss of parts or subject-  
ing the product to any but the specified batteries.* Use of unauthorized  
replacement parts will void this warranty.  
PHILIPS ELECTRONICS NORTH AMERICA CORPORATION WILL NOT  
PAY FOR WARRANTY SERVICE PERFORMED BY A NON-AUTHO-  
RIZED REPAIR SERVICE AND WILL NOT REIMBURSE THE CON-  
SUMER FOR DAMAGE RESULTING FROM WARRANTY SERVICE PER-  
FORMED BY A NON-AUTHORIZED REPAIR SERVICE.  
9. Do not attempt to recharge alkaline, heavy-duty or regular  
batteries in a nickel cadmium battery charger.  
INSTRUCTIONS  
When using a battery operated appliance, basic safety pre-  
cautions should always be followed, including the following:  
Read all instructions before using this appliance.  
T-5000  
SAVE THESE  
INSTRUCTIONS  
Cordless Beard  
and Moustache  
Trimmer  
WARNING  
To reduce the risk of burns, fire or injury to persons:  
Instructions  
for use  
1. Close supervision is necessary when this appliance is used  
by, on, or near children or the disabled.  
NO RESPONSIBILITY IS ASSUMED FOR ANY SPECIAL, INCIDENTAL  
OR CONSEQUENTIAL DAMAGES.  
In order to obtain warranty service, simply take or ship the product  
postage prepaid to the nearest Authorized Norelco Service Location. It  
is suggested that for your protection you return shipments of product  
by insured mail, insurance prepaid. Damage occurring during ship-  
ment is not covered by this warranty. NOTE: No other warranty, writ-  
ten or oral, is authorized by Philips Electronics North America  
Corporation. This warranty gives you specific legal rights, and you may  
also have other rights which vary from state to state. Some states do  
not allow the exclusion or limitation of incidental or consequential  
damages, so the above exclusion and limitations may not apply to you.  
2. Use this appliance for its intended household use as  
described in this manual. Do not use attachments not rec-  
ommended by Philips Electronics North America  
Corporation.  
3. Never operate this appliance if it is not working properly,  
if it has been dropped or damaged, or dropped into water.  
Return the appliance to an Authorized Norelco Service  
Location for examination and repair.  
If you need help, answers or  
service, please call us at  
1-800-243-3050  
Manufactured for: Norelco Consumer Products Company  
A Division of Philips Electronics North America Corporation  
1010 Washington Blvd., Stamford, CT 06912-0015  
4. Never drop or insert any object into any opening.  
5. Do not operate where aerosol (spray) products are being  
used or where oxygen is being administered.  
MADE IN AUSTRIA.  
Norelco is a Registered Trademark of  
Philips Electronics North America Corporation.  
PHILIPS and Philips Shield are Registered Trademarks of  
Philips Electronics N.V.  
6. Do not use this appliance with a damaged or broken cutter,  
as facial injury may occur.  
7. If trimmer is not used on a regular basis, remove batteries  
to prevent possible damage due to chemical leakage. If bat-  
teries do leak, remove them carefully. Do not allow bare  
skin to touch leaking fluid.  
© 1998 Philips Electronics North America Corporation.  
All Rights Reserved.  
®
INGENIOUS MEN’S GROOMING SOLUTIONS  
 
Batteries  
Hair Length Selector  
Trimmer Guard Attachment  
NOTE: Battery compart-  
NOTE: Trimmer will not  
operate if batteries are  
inserted incorrectly. If you  
do not intend to use the  
appliance for a long time,  
remove the batteries.  
Trimmer Guard  
Start at a longer setting  
(#7, 8 or 9) to prevent  
accidentally trimming  
hairs too short (Fig. 5).  
To Remove  
the OFF position.  
IMPORTANT: If using Trimmer  
without Trimmer Guard  
Attachment, use a slow, very  
light “skimming” technique to  
prevent trimming off more than  
the desired amount of hair.  
Your new Trimmer requires  
2 “AA” 1.5 V alkaline or  
carbon zinc batteries.  
ment is not removable.  
Attachment must be in  
place on the Trimmer in  
order to use the Zoom  
Ring.  
Remove Trimmer Guard  
Attachment if you are:  
2. Hold Trimmer in one hand  
and replace Attachment  
back onto Trimmer until it  
“clicks” into position.  
3. Insert the batteries as  
shown making sure the (+)  
and (-) markings on the  
batteries match those on  
inside compartment of  
Trimmer (Fig. 2).  
To Insert Batteries  
Defining hair lines  
• Trim against the direction  
of hair growth (Fig. 6)  
1. Be certain Trimmer is in  
the OFF position.  
Trimming nape of neck  
Zoom Ring with Trimmer  
Guard Attachment ensures  
precise trimming and has  
9 adjustable settings (see  
chart below).  
NOTE: The Trimmer Guard  
Attachment can be placed  
on Trimmer only one way.  
If it does not fit properly,  
reverse it.  
Leaking batteries can cause  
damage to the product.  
To Trim Outer Edge of Beard  
& Add Definition  
Removing single, unwant-  
ed hairs  
As you become familiar  
with the settings, adjust  
Zoom Ring to desired  
trimming length.  
2. Hold Trimmer horizontally  
and press the release tabs  
located at base of  
Trimmer. Gently slide bat-  
tery compartment out of  
Trimmer housing until it  
stops (Fig. 1)  
To Remove Batteries  
4. Slide the battery  
compartment back into  
Trimmer housing (Fig. 3).  
1. Remove Trimmer Guard  
Attachment.  
1. Be certain Trimmer is in  
the OFF position.  
1. Follow steps 1-2 above.  
Push the batteries out of the  
holder as shown (Fig. 4).  
Zoom Ring will “click” into  
position at each setting.  
To Trim Beard  
2. Hold Trimmer diagonally  
with front of Trimmer fac-  
ing away from you (Fig. 9).  
2. Hold Trimmer base with  
one hand, grasp sides of  
Trimmer Guard Attach-  
ment and gently slide  
Attachment off Trimmer  
(Fig. 7).  
1. Comb hairs outward so  
that they are at their maxi-  
mum height and in the  
same direction.  
#1  
#2  
#3  
#4  
#5  
#6  
#7  
#8  
#9  
Stubble Length or Closely Cropped .06 in./1.5 mm  
Short  
3. Turn Trimmer ON.  
.1 in./2.5 mm  
.16 in./4 mm  
.22 in./5.5 mm  
.3 in./7.5 mm  
.38 in./9.5 mm  
.48 in./12 mm  
.6 in./15 mm  
.72 in./18 mm  
2
4. Start at chin and work  
back toward ear.  
2. With Trimmer Guard  
Attachment in place,  
set Zoom Ring to desired  
setting.  
NOTE: Zoom Ring can be  
on any setting when  
removing or replacing  
Trimmer Guard  
Medium  
5. Follow line of jawbone to  
cut away longer hairs on  
outer edge of beard.  
3. Slide On/Off switch to the  
ON position and begin  
trimming (Fig. 8).  
Attachment.  
6. Turn Trimmer OFF.  
Long  
To Replace  
NOTE: Practice is best for  
optimum results.  
1. Be certain Trimmer is in  
4. Turn Trimmer OFF.  
1
6
7
9
4
8
3
5
9
7
8
6
CLICK  
 
Trimmer Guard Attachment (continued)  
Maintenance  
IMPORTANT  
To Define Beard Line  
Hold Trimmer vertically  
with front of Trimmer fac-  
ing you.  
NOTE: Use a slow and  
gentle pressure. Too  
much pressure may trim  
more hair than desired.  
To Achieve The  
“Stubble” Look  
During Use  
To Replace Cutters  
3. Push the cutting unit back  
until it “clicks” into place  
(Fig. 19).  
1. Hold Trimmer vertically  
with front of Trimmer fac-  
ing you.  
Always switch Trimmer  
OFF before cleaning.  
If cut hairs have accumu-  
lated in the comb area,  
pull Trimmer Guard  
If your cutters become dam-  
aged or worn, do not contin-  
ue using the Trimmer.  
The Trimmer Guard  
Trim hairs using a down-  
ward motion following the  
direction of your hair  
growth or you may trim  
against your hair growth—  
whichever is preferred.  
Attachment is unique  
because it has a small slot  
between the two rows of  
teeth enabling you to trim  
hairs to only .06  
Never clean, remove or  
replace Trimmer Guard  
Attachment with motor on.  
17  
5. Turn Trimmer OFF.  
Attachment off Trimmer  
(Fig. 13) and remove hairs  
by shaking and/or blowing  
(Fig. 14).  
Replace cutters immediately.  
2. Start with trimmed edge  
of beard and with down-  
ward motions trim area  
directly under the beard  
line.  
To Trim Sideburns  
1. Remove the old cutters by  
pushing cutting unit back-  
wards (see Fig. 15) and  
then pull it upwards off  
Trimmer.  
1. Comb sideburns following  
the direction of your hair  
growth.  
Do NOT apply pressure to  
cutters.  
in./1.5mm in length.  
Once A Week  
Do NOT touch cutters  
with hard objects as this  
may damage them.  
NOTE: Since all hairs do  
not grow in the same  
direction, you may want  
to try different trimming  
positions (i.e. upwards,  
downwards or across).  
Practice is best for opti-  
mum results.  
1. Be certain Trimmer Guard  
Attachment is ON and  
Zoom Ring is on the low-  
est setting (#1).  
To Thin and Taper Beard  
1. Be certain Trimmer is in  
OFF position.  
2. Be certain Trimmer Guard  
Attachment is ON.  
2. Place the two notches of  
the new cutting unit into  
the guide slots (Fig. 18).  
1. Use a small comb to hold  
hairs in place while trim-  
ming.  
2. Remove Trimmer Guard  
Attachment.  
3. Hold Trimmer vertically  
with front of Trimmer fac-  
ing you.  
If Trimmer is not used reg-  
ularly, remove batteries to  
prevent possible damage  
due to chemical leakage.  
2. Hold Trimmer horizontally  
with front of Trimmer fac-  
ing downwards or upwards.  
2. Hold Trimmer with front  
of Trimmer facing away  
from you.  
3. Hold Trimmer as shown  
and gently push cutter tab  
(located beneath the cut-  
ters) backwards (Fig. 15).  
18  
15  
4. Trim sideburns using a  
downward motion.  
DO NOT use while  
3. Trim hairs using a down-  
ward or upward motion,  
whichever is more com-  
fortable, following the  
direction of your hair  
growth (Fig. 11).  
To Trim Moustache without  
Trimmer Guard Attachment  
3. Trim hair ends using an  
upward motion.  
bathing, showering or  
immerse the unit in water  
or other liquids as damage  
to Trimmer may occur.  
5. Turn Trimmer OFF.  
4. Lightly brush out cutters,  
hair chamber and  
Trimmer Guard Attach-  
ment (Fig. 16 &17) with  
cleaning brush provided.  
1. Remove Trimmer Guard  
Attachment.  
4. Turn Trimmer OFF.  
To Trim Moustache with  
Trimmer Guard Attachment  
NEVER use harsh or cor-  
rosive cleaners such as  
benzene or bleach.  
2. Place a finger on upper lip  
to lift hair up, away from  
skin.  
4. Turn Trimmer OFF.  
Be certain Trimmer Guard  
Attachment is on to pre-  
vent trimming off too  
many hairs.  
3. Trim hairs using an  
upward motion.  
16  
11  
13  
14  
10  
19  
2
4. After achieving desired  
length, use a downward  
motion to blend mous-  
tache hairs (Fig. 10).  
1. Comb hairs outward so  
they are at their maximum  
height and in the same  
direction.  
1
2
CLICK  
2. Set Zoom Ring to desired  
setting.  
1
 

Pentax Camcorder ZX L User Manual
Philips Cassette Player AW7150 User Manual
Philips Digital Camera LTC0500 User Manual
Philips Digital Photo Frame SPF7008 User Manual
Philips Stereo System 190B5CS User Manual
Philips Stereo System SDV2710 27 User Manual
Pioneer Stereo Amplifier GM 6400F User Manual
Power Acoustik Car Video System PMD 90CM User Manual
ProForm Treadmill 831294230 User Manual
Proxim Radio Antenna CPN 65756B User Manual