Always there to help you
Register your product and get support at
BT1300
Question?
Contact
Philips
User manual
Contents
EN
1
1 Important
Warning
• Never remove the casing of this speaker.
• Never lubricate any part of this speaker.
• Never place this speaker on other electrical equipment.
• Keep this speaker away from direct sunlight, naked
flames or heat.
•
•
•
Make sure that there is enough free space
around the speaker for ventilation.
Only use attachments or accessories
specified by the manufacturer.
The battery shall not be exposed to
excessive heat such as sunshine, fire or the
like.
•
•
The speaker shall not be exposed to
dripping or splashing.
Do not place any sources of danger on
the speaker (e.g. liquid filled objects, lighted
candles).
Note
• The type plate is located on the back of the product.
2
EN
2 Your Bluetooth
speaker
Congratulations on your purchase, and
welcome to Philips!To fully benefit from the
support that Philips offers, register your product
Introduction
With this speaker, you can enjoy audio from
your Bluetooth-enabled devices, or other
external audio devices.
What's in the box
Check and identify the contents of your
package:
•
•
•
•
•
Speaker
USB cable for charging
String for carrying
Short user manual
Safety and notice leaflet
Always there to help you
Register your product and get support at
Question?
Contact
Philips
Short user manual
EN
3
Overview of the speaker
a
b
c
d
e
a LED indicator
b
•
•
•
•
•
Disconnect Bluetooth connection.
Enter Bluetooth pairing mode.
Answer or reject an incoming call.
End the current phone call.
Transfer the call to your mobile device.
c DC IN
Recharge the built-in battery with a
USB cable.
•
d AUDIO IN
•
Connect an external audio device.
e OFF/AUDIO IN/
•
Select Bluetooth or AUDIO IN source.
•
Turn the speaker off.
4
EN
3 Get started
Always follow the instructions in this chapter in
sequence.
Attach the string
DC IN
For easy carrying, attach the supplied string to
this speaker as illustrated.
Charging indicator status
The LED indicator indicates the battery status.
Under charging Fully charged
"OFF"
Flashing white
Off
mode
"AUDIO
IN" mode
Flashing white
Solid white
"Bluetooth" Flashing blue
Flashing blue
or solid blue
(depending
on Bluetooth
connection
status)
mode
or solid blue
(depending
on Bluetooth
connection
status)
Charge the built-in battery
The speaker is powered by a built-in
rechargeable battery.
Turn on/off
•
To turn the speaker on, slide the
Note
OFF/AUDIO IN/ switch to or AUDIO
IN.
• Before use, fully charge the built-in battery.
• The micro USB socket is for charging only.
• Rechargeable battery has a limited number of charge
cycles. Battery life and number of charge cycles vary by
use and settings.
•
•
: Listen to an external Bluetooth
device through Bluetooth connection.
AUDIO IN: Listen to an external
device through an audio input cable.
•
To turn the speaker off, slide the switch to
OFF.
Connect the supplied USB cable between
•
•
the DC IN socket on the speaker, and
a USB socket of a computer.
EN
5
To disconnect the Bluetooth-enabled device:
4 Play
•
•
•
Press and hold
for two seconds;
Disable Bluetooth on your device; or
Move the device beyond the
communication range.
» The LED indicator flashes blue.
Use Bluetooth devices
To reconnect the Bluetooth device:
•
Next time you turn on the speaker, the
speaker will reconnect the last connected
device automatically; or
On your Bluetooth device, select "Philips
BT1300" on your Bluetooth menu to start
pairing.
With this speaker, you can listen to audio from
Bluetooth-enabled devices and control the
incoming call through Bluetooth.
•
Play from Bluetooth devices
To connect another Bluetooth-enabled device:
Note
1 Press and hold
for two seconds to
• Make sure that your Bluetooth device is compatible
with this speaker.
• Before pairing a device with this speaker, read its user
manual for Bluetooth compatibility.
disconnect the currently connected device;
» The speaker enters Bluetooth pairing
mode.
• The speaker can memorize a maximum of 4 paired
devices.
• Make sure that Bluetooth function is enabled on your
device, and your device is set as visible to all other
Bluetooth devices.
• Any obstacle between this speaker and a Bluetooth
device can reduce the operational range.
• Keep away from any other electronic device that may
cause interference.
2 Connect another Bluetooth device.
LED indicator
Description
Flashing blue
Connecting;
Waiting for pairing
Solid blue
Connected
• The operational range between this speaker and a
Bluetooth device is approximately 10 meters (30 feet).
• If there is an incoming call on the connected mobile
phone, music playback pauses.
Control your phone call
After Bluetooth connection, you can control an
incoming call with this speaker.
1 Slide the OFF /AUDIO IN/ switch to .
» The LED indicator flashes blue.
Button Function
2 On your Bluetooth device, enable
Bluetooth and search for Bluetooth devices
that can be paired (refer to the user
manual of the device).
Press to answer an incoming call.
Press and hold to reject an incoming
call.
During a call, press to end the current
call.
3 When [Philips BT1300] is displayed on
your device, select it to start pairing and
connection. If necessary, input “0000” as
the pairing password.
During a call, press and hold to
transfer the call to your mobile device.
» After successful pairing and connection,
the speaker beeps twice, and the LED
indicator turns solid blue.
Note
• Music play pauses when there is an incoming call, and
resumes when your phone call ends.
4 Play audio on the Bluetooth device.
» Audio streams from your Bluetooth
device to the speaker.
6
EN
Play from external devices
With this speaker, you can also listen to an
external audio device such as an MP3 player.
1 Connect an audio input cable (not
supplied) with a 3.5 mm connector on
both ends to
•
the AUDIO IN socket on this speaker,
and
•
the headphone socket on the external
device.
AUDIO-IN
2 Slide the OFF /AUDIO IN/ switch to
AUDIO IN.
» The LED indicator becomes white.
3 Play audio on the external device (refer to
its user manual).
Adjust volume
During play, use the volume control on your
Bluetooth or external device to adjust volume.
EN
7
General information
Power Supply
(through USB socket)
Built-in Battery
5 Product
information
5V 0.5 A
Li-polymer battery
(3.7V, 500 mAh)
55 x 55 x 55 mm
Note
Dimensions - Main Unit
(W x H x D)
Weight - Main Unit
• Product information is subject to change without prior
notice.
0.1 kg
Specifications
Amplifier
Rated Output Power
Frequency Response
Signal to Noise Ratio
Audio-in Input
2 W RMS
80 -16000 Hz, ±3 dB
>70 dBA
300 mV RMS
Speakers
Speaker Impedance
Speaker Driver
Sensitivity
4 ohm
4.5 cm full range
>81dB/m/W±3dB/
m/W
Bluetooth
BluetoothVersion
V3.0
Bluetooth Profile
HFP, HSP,A2DP
Bluetooth Frequency 2.4 GHz ~ 2.48 GHz
Brand
Bluetooth Range
10 m (Free space)
8
EN
The paired device connects and disconnects
constantly.
6 Troubleshooting
•
The Bluetooth reception is poor. Move the
device closer to this product or remove
any obstacle between them.
Warning
•
For some devices, Bluetooth connection
may be deactivated automatically as a
power-saving feature.This does not indicate
any malfunction of this product.
• Never remove the casing of this device.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
device, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips Web page (www.
philips.com/support).When you contact Philips,
make sure that the device is nearby and the
model number and serial number are available.
General
No power
•
Recharge your speaker.
No sound or poor sound
Adjust volume on the connected device.
No response from the speaker
Restart the speaker.
•
•
About Bluetooth device
The audio quality is poor after connection
with a Bluetooth-enabled device.
•
The Bluetooth reception is poor. Move the
device closer to this product or remove
any obstacle between them.
Cannot connect with the device.
•
The Bluetooth function of the device is not
enabled. Refer to the user manual of the
device for how to enable the function.
This product is already connected with
another Bluetooth-enabled device.
•
Disconnect that device and then try again.
Fail to search out BT1300 on your device for
pairing.
•
Press and hold
then try again.
for three seconds, and
EN
9
be disposed of with normal household waste.
We strongly advise you to take your product to
an official collection point or a Philips service
centre to have a professional remove the
rechargeable battery.
Inform yourself about the local separate
collection system for electrical and electronic
products and rechargeable batteries. Follow
local rules and never dispose of the product
and rechargeable batteries with normal
household waste. Correct disposal of old
products and rechargeable batteries helps
prevent negative consequences for the
environment and human health.
7 Notice
Any changes or modifications made to this
device that are not expressly approved by
WOOX Innovations may void the user’s
authority to operate the equipment.
Compliance
Caution
Hereby,WOOX Innovations declares that this
product is in compliance with the essential
requirements and other relevant provisions
of Directive 1999/5/EC.You can find the
Declaration of Conformity on www.philips.com/
• Removal of the built-in battery invalidates the warranty
and may destroy the product.
Always bring your product to a professional to
remove the built-in battery.
A
Care of the environment
Disposal of your old product and battery
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
This symbol on a product means that the
product is covered by European Directive
2012/19/EU.
Environmental information
All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separate into three materials: cardboard (box),
This symbol means that the product contains
a built-in rechargeable battery covered by
European Directive 2013/56/EU which cannot
10 EN
polystyrene foam (buffer) and polyethylene
(bags, protective foam sheet.)
Your system consists of materials which can
be recycled and reused if disassembled by
a specialized company. Please observe the
local regulations regarding the disposal of
packaging materials, exhausted batteries and old
equipment.
Trademark notice
The Bluetooth® word mark and logos are
registered trademarks owned by Bluetooth
SIG, Inc. and any use of such marks by WOOX
Innovations is under license.
EN 11
2014 ©WOOX Innovations Limited.All rights reserved.
Philips and the Philips’ Shield Emblem are registered trademarks of Koninklijke Philips N.V.
and are used byWOOX Innovations Limited under license from Koninklijke Philips N.V.
BT1300_00_UM_V2.0
|