Subwoofer Manual
Manuel de subwoofer
Models: SXt10d2, SXt10d4, SXt12d2, SXt12d4
Features
Caractéristiques
• One Piece Polypropylene Dustcap
• Pare-poussière monopièce
• High Temperature 2.0 Inch OFC Voice Coils
• Die Cast Aluminum Heatsink Spider Spacer
• Optimized for Sealed or Vented Enclosures
• Rigid Powder Coated Steel Frame
• Aluminium moulé dissipateur thermique spider spacer
• Bobines acoustiques en cuivre exempt d’oxygène à
haute température
• Panier rigide en acier
• Nickel Plated 12 Gauge Speaker Terminals
• High Excursion Motor Design
• Bornes d’enceinte nickelées de calibre 12
• Modèle de moteur à grand battement
Subwoofer Owner’s Manual
Vented Enclosure Recommendations
SXt10d2
SXt10d4
SXt12d2
SXt12d4
VENTED - SPL
Volume(cu.ft.)
Vent Opening(in.)
Vent Length(in.)
Tuning Freq
1.25
2 x 8
21
1.75
2 x 10
18
44Hz
40Hz
SXt10d2
SXt10d4
SXt12d2
SXt12d4
VENTED - Normal
Volume(cu.ft.)
Vent Opening(in.)
Vent Length (in.)
Tuning Freq
1.5
2.0
2 x 8
22.75
38Hz
2 x 10
21.5
35Hz
SYSTEM EXAMPLES
SXt12d4 or SXt10d4
Dual 4 ohm Subwoofer
(wired in parallel)
SINGLE SUBWOOFER SYSTEM
RX250.1 Terminal
All voice coils are wired in parallel for 2 ohm load.
RX250.1 makes maximum power into a 2 ohm load.
+
+
Toutes les bobines mobiles sont câblées en parallèle de 2 Ohms.
RX250.1 faire puissance maximale en 2 Ohms.
-
-
SXt12d4 or SXt10d4
DUAL SUBWOOFER SYSTEM
Dual 4 ohm Subwoofers
(wired in parallel)
SX600.1 Terminal
All voice coils are wired in parallel for 1 ohm load.
SX600.1 makes maximum power into 1 ohm load.
+
+
+
+
Toutes les bobines mobiles sont câblées en parallèle pour
1 Ohm. SX600.1 rend la puissance maximale de charge en
1 ohm.
-
-
-
-
Specifications
SXt10d2
.85
SXt10d4
1.65
SXt12d2
.85
SXt12d4
1.65
T/S Parameters:
Re (Dcr)
FS (Hz)
39.5
40.3
33.4
33.1
Sd (SqM)
BL TM
.033
.033
.051
.051
6.7
7.8
6.3
7.8
Qms
2.79
3.05
2.13
2.61
Qes
.577
.775
.735
.959
Qts
.48
.62
.55
.7
Vas (liters)
Cms (uM/N)
Mms (gms)
SPL
22.63
132.85
122.40
90dB
Dual 2
23.59
138.45
112.59
90dB
Dual 4
56.20
140.40
161.33
90dB
Dual 2
54.99
137.36
168.22
90dB
Dual 4
Impedance
*Specifications subject to change
SXt10d2
SXt12d2
Specifications:
SXt10d4
300 watts
25mm
SXt12d4
300 watts
25mm
RMS Power Handling
Xmax (Peak to Peak)
Mounting Diameter**
Mounting Depth
9in - 230mm
3.6in - 92mm
11in - 280mm
4.25in - 108mm
**Install Tip: Remove the mounting gasket from the subwoofer and use it as a mounting hole template.
Phoenix Gold
A Division of AAMP of America™
13190 56th Court
Clearwater, Florida 33760
P: 866-788-4237
© 2014 AAMP of Florida, Inc
Designed and Engineered in the USA
LIMITED WARRANTY
Phoenix Gold warrants this product to be free of defects in materials and workmanship for a period of one (1) year from the original date of purchase. This
warranty is not transferable and applies only to the original purchaser from an authorized Phoenix Gold dealer in the United States of America only. Should
service be necessary under this warranty for any reason due to manufacturing defect or malfunction, Phoenix Gold will (at its discretion), repair or replace the
defective product with new or remanufactured product at no charge. Damage caused by the following is not covered under warranty: accident, misuse, abuse,
product modification or neglect, failure to follow installation instructions, unauthorized repair attempts, misrepresentations by the seller. This warranty does not
cover incidental or consequential damages and does not cover the cost of removing or reinstalling the unit(s). Cosmetic damage due to accident or normal wear
and tear is not covered under warranty.
INTERNATIONAL WARRANTIES:
Products purchased outside the United States of America are covered only by that country’s Authorized Phoenix Gold reseller and not by Phoenix Gold.
Consumers needing service or warranty information for these products must contact that country’s reseller for information.
|