Pride Mobility Mobility Aid KD User Manual

KNOCK-DOWN (KD) LIFT CHAIR OUT-OF-BOX SETUP  
Congratulations, you have received a KD Lift Chair developed by Pride for your convenience. Please follow the setup instructions below.  
Your lift chair will arrive packaged in the KD position. See figure 1.  
NOTE: The illustrations shown may not reflect the model of lift chair that you own.  
To Attach the Back Portion of the Lift Chair:  
1. Remove packaging and check to ensure the locking clip is in the vertical position. Reposition if necessary. See figure 2.  
2. Slide the left and right rear bracket sleeves of the chair back onto the male brackets on the arms and seat of the chair. See figure 3.  
NOTE: Because of the chair width, you may have to slide on one side of the chair back at a time. If  
so, level the chair back before pressing down to lock into position.  
3. Push firmly on the top of the chair back to lock into position. Listen for a click on each side to ensure the chair back is locked in  
properly. See figure 4.  
NOTE: Pull up on the chair back to ensure that it is locked in place. If the back can be pulled off, then  
repeat back portion installation.  
4. Attach the chair back fabric to the hook and loop flaps on the bottom of the chair base. See figure 5.  
To Remove the Back Portion of the Lift Chair:  
1. Remove the bottom of the back fabric from the hook and loop flaps on the chair base. See figure 6.  
2. Using a large flat head screwdriver, lift the left and right clips of the chair back to raise the back from the brackets on the chair base.  
As you lift the clip, pull up on the back to lift that side over the lock. See figure 7.  
NOTE: You will have to do this step one side at a time due to the width of your chair.  
3. Lift the chair back up from the base of the chair. See figure 8.  
CHAIR BACK  
LOCKING  
CLIP  
REAR  
BRACKET  
SLEEVE  
"CLICK"  
MALE KD  
BRACKET  
ARMS AND SEAT  
Figure 1. Knock-Down  
(KD) Position  
Figure 2. Locking Clip  
Position  
Figure 3. Sleeve and  
Bracket Connections  
Figure 4. Position Lock  
Figure 5. Chair Back Hook  
and Loop Flaps (Installation) and Loop Flaps (Removal)  
Figure 6. Chair Back Hook Figure 7. Clip Lifting  
Figure 8. Chair Back  
Removal  
INFINFB1670/Rev. A/11-18-04  
 

Pelco Home Security System C3422M B User Manual
Pentair Swimming Pool Pump WhisperFlo User Manual
Phase One Digital Camera 85280002 User Manual
Philips Handheld TV PT9000 User Manual
Philips Headphones HL125 User Manual
Philips Speaker SBC BA120 User Manual
Pitney Bowes Postal Equipment N400 User Manual
Pitney Bowes Scale G799 User Manual
Polycom Network Cables VSX 7000 User Manual
PYLE Audio Car Video System PLMDR7 User Manual