Sanyo Projector Accessories LNS M01 User Guide

LCD PROJECTOR LENS  
MODEL NO. LNS-M01  
LNS-S01  
LENS REPLACEMENT AND  
INSTALLATION PROCEDURE  
NOTES ON LENS INSTALLATION  
Lens installation should be performed by the qualified service personnel.  
It should be followed by this procedure precisely.  
Before attempt to install the lens, confirm the model number (both the LCD  
projector and the lens) and use the proper lens.  
If you have any questions, contact to the dealers.  
PARTS LIST  
Following parts are contained in the packing.  
· LENS  
1 piece  
· LENS MOUNTING SCREWS  
· DRIVER  
6 screws (2 for spare)  
1 piece  
· LIGHT-BLOCK SHEET  
1 sheet  
Following checks and confirmations should be taken for safety.  
Check the following things by the time of the cabinet assembly after the  
lens installation.  
1. Confirm the lens is securely fixed by 4 screws.  
2. Wiring must not be tangled in the gear of the lens motor or the other  
mechanical part.  
3. There is no missing part, or no loosing mounting part.  
1AA6P1P1980-- (ICPP)  
 
INSTALL THE LENS. (See figure-4,5.)  
3
LENS MOUNTING BRACKET  
1. Mount the lens at the lens  
mounting bracket with screws  
(4 screws) included with the  
lens. Use the driver included  
with the lens to fasten the  
screws . (After using, save it for  
latter use.)  
ATTACHED DRIVER  
2. Connect the lens motor lead to  
the connector “K16B” of the cir-  
cuit board.  
3. Fasten the lens motor lead at  
the A, B points with wire holder.  
Fig-4  
LIGHT-BLOCK SHEET  
Figure shown inside of the cabinet.  
LENS MOTOR  
(D)  
(D)  
(D)  
(D)  
B
A
WIRE HOLDER  
This part wiring should  
not be tightened.  
LENS  
MOTOR LEAD  
Fig-5  
CONNECTOR “ K16B “  
MOUNT THE LENS COVER. (See figure-1)  
4
When in install the both upper and lower lens covers,  
put the light-block sheet through the lens and install  
the sheet so that it should be placed in the guide slot  
of the lens cover. If the installation of the light-block  
sheet is incorrect, there will be the space between  
lens and the lens cover, so that it will be the cause of  
leakage of light or the dust entering at the main cab-  
inet.  
 

Quantum Water Heater 150 08ACW 134 User Guide
Radica Games Games I9037 User Guide
Rheem Water Heater AP15317 User Guide
Roadmaster Car Speaker VRS693 User Guide
Samsung Bluetooth Headset SCH A212 User Guide
Sanitaire Vacuum Cleaner SC6070 User Guide
Sanyo Projector 1AV4U19B25500 User Guide
Sanyo TV Receiver HT27744 User Guide
Savin Printer SLP38C User Guide
SECO LARM USA Security Camera EV 2221 N3BQ User Guide