Baby Trend Baby Accessories 1638CT User Manual

Read all instructions BEFORE assembly and USE of product.  
KEEP INSTRUCTIONS FOR FUTURE USE.  
MODEL # 1638CT  
Providence Ridge Travel System  
Instruction Manual  
Convenience through Innovation and thoughtful design  
11.06  
 
PARTS  
Child Tray  
Parent Tray  
Base  
Locking Cap  
Hub Cap  
Rear Wheels  
Rear Axle Assembly  
Stroller  
Solid Cap  
Front Wheels  
Car Seat  
TO ENSURE SAFE OPERATION OF YOUR STROLLER, PLEASE FOLLOW THESE  
INSTRUCTIONS CAREFULLY. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.  
TO ASSEMBLE STROLLER  
* Remove stroller from box. The front wheels, rear wheels, and child tray,  
and parent tray need to be installed prior to use.  
* To attach the front wheels, slide the red unlock mechanism and squeeze  
the stroller handle while pulling backward on the stroller to unfold. See  
figures 1 and 2.  
* Lean the stroller backwards so that it rests on the handle and rear frame  
tubes and the front wheel tubes are pointing upward. Position the front  
wheel assembly at the front tube such that the hole in the swivel assembly  
will slide onto the front tube. Please see figure 3. Push each front wheel  
assembly onto the front tube being careful that wheel assembly locks onto  
the front leg. Pull on the wheel assembly to ensure that it is securely  
attached to the stroller. Please see figure 3.  
Figure 1.  
Figure 2.  
* Lean the stroller forward to rest on the front wheels. Assemble the rear  
wheels as follows:  
1. Slide the rear axle assembly onto the rear stroller legs until they lock  
into place. Please see figure 4.  
2. Slide each wheel onto the rear axle and secure in place with the  
Locking Cap. Snap the solid cap over the Locking Cap. Snap the  
Hub Cap onto the wheel. Please see figure 5. Please see figure 6 for  
order assembly.  
Figure 3.  
Pull on each wheel to ensure that each is firmly attached to the axle.  
* Ensure that the wheels are firmly locked into place. Do Not use the stroller  
if the wheels are not locked into place, but rather contact our customer  
service department immediately at (800) 328-7363, between the hours of  
8:00am and 4:30pm PCT, for assistance.  
Figure 4.  
Figure 5.  
Figure 6.  
3
 
* To attach the front child tray, push the angled tray onto the post at the  
end of the right armrest, while pressing downward on the snap button,  
until locked into place. Please see figure 7. Rotate the tray downward  
until latched onto the left armrest. Please check that the snap button  
comes through and securely latches the tray in place. Please see figure  
8.  
* To remove front child tray, press inward on the left side tray release  
button and rotate upward on the tray. Please see figure 9. Please note  
that you may remove the tray completely by depressing the snap button  
on the right side as shown in figure 10 while pulling forward on the tray.  
Please see figure 7.  
Figure 7.  
* To install the canopy slide the male ends of the canopy into the female  
slots on the stroller frame. Please see figure 11. To open the canopy  
push forward on the front frame tube of the canopy. Please see figure  
12.  
* To attach the parent tray line up the parent tray slots with the  
corresponding slots on the stroller frame, slide down until it locks into  
place. Check to make sure the parent tray is secure before using. Please  
see figure 14  
Figure 8.  
* To remove the parent tray, locate the locking tabs under the tray, pull  
outward on the locking tabs and lift up to remove. Please see figure 15  
Figure 9.  
Front frame  
tube  
Figure 12.  
Figure 11.  
Figure 10.  
Figure 15.  
Figure 14.  
4
 
TO SECURE THE CHILD  
• The shoulder straps of the 5-point harness have 3 attachment positions.  
Select the position that places the shoulder strap level with, or below  
the top of the child's shoulder. To access the harness pull apart seat pad.  
Please see figure 16.  
• Carefully place the child in the stroller seat and bring the safety harness  
around the child's waist and over the shoulders. Place the crotch strap  
between the child's legs. Insert the male end of each shoulder/waist belt  
into the buckle on the crotch strap. Tighten the harness to be snug around  
the child's waist and over the child's shoulders Please see figure 17.  
Figure 16.  
Shoulder Strap  
Waist  
Strap  
Squeeze  
Adjust for a  
snug fit  
Crotch Strap  
Figure 18.  
Figure 17.  
• To release, apply pressure to both sides of each male clip until the clip is released. See figure  
18. This process requires a moderate amount of effort so as to prevent an accidental release by  
your child.  
WARNING:Avoid serious injury from  
falling or sliding out. Always use the safety  
harness.  
STRANGULATION HAZARD:  
Child can strangle in loose straps. Never leave  
child in seat when straps are loose or undone.  
5
 
ATTACHMENT OF THE BABY TREND INFANT CAR SEAT  
* To attach the Baby Trend Infant Car Seat, recline the seat all the way  
back. Please see figure 19  
* Check that the front child tray is firmly attached to the stroller  
armrests. Make sure that the car seat locks into the front child tray. Then  
turn tabs on stroller frame to lock the front of the car seat into the stroller.  
See figure 20.  
* Position the Infant Car Seat, facing toward the rear of the stroller, so  
that the seat shell goes into the front tray and latches into place. Please  
see figure 21. Check that the Infant Car Seat is firmly locked onto  
the front tray before using.  
* To remove the Infant Car Seat, squeeze the release handle located at the  
Figure 19.  
foot-end of the seat and carefully lift upward on the seat. Please see  
figure 23.  
Locks  
into tray  
Figure 20.  
Figure 21.  
WARNING:Failure to follow these  
car seat attachment instructions could re-  
sult in serious injury or death.  
Figure 22.  
6
 
SEAT BACK POSITIONING  
WARNING: The upright position should  
be used only for a child that is at least 6 months  
old.  
* The seat has a multiple position recline that is controlled by a cord and  
spring loaded adjuster behind the seat. To recline the seat, pull back on  
the loop of the adjuster. Please see figure 23. To place the seat back in  
a more upright position, grab the adjuster with one hand and pull the  
cord to the desired position with the other hand. See figure 24.  
The cord will lock automatically.  
Figure 23.  
Figure 24.  
BRAKES  
WARNING: Always set brakes when the  
stroller is not being pushed so that the stroller will not  
roll away. Never leave stroller unattended on a hill or  
incline as the stroller may slide down the hill.  
* To engage brakes, apply light downward pressure to the brake lever  
located on each rear wheel. The stroller may require slight forward or  
rearward movement in order to line up the teeth on the brake with each  
wheel brake cluster. See figure 25. Check that the stroller will not move  
and that the brakes are properly applied. To release, gently lift up on the  
brake lever.  
Figure 25.  
7
 
CANOPY  
Front frame  
tube  
* To open the canopy, push forward on the front frame of the canopy. To  
close canopy, pull the front edge toward the rear of the stroller until  
folded. Always fold the canopy prior to folding the stroller frame. Please  
see figure 26.  
Figure 26.  
CAUTION: Read the following section completely before folding your stroller!  
TO FOLD STROLLER  
* Close the canopy as described in the canopy section. NOTE: For an  
easier fold place the seat in the furthest recline position. Also you  
must flip the carseat support tabs to the outside of the stroller frame  
before folding. To fold the stroller slide the red fold lock with your  
thumb while squeezing the large red fold button in the center of the  
handle and push forward on the handle. Please see figure 27. Once the  
stroller begins to fold, release the red handle and push forward on the  
handle until the stroller is folded. Please see figure 28. To stroller will  
automatically lock when folded correctly, and will stand freely in the  
folded position.  
Figure 27.  
WARNING:Failure to  
follow these folding instructions  
could result in serious injury or  
death.  
Figure 28.  
8
 
TO UNFOLD STROLLER  
* To unfold the stroller slide the red fold lock with your thumb while  
squeezing the large red fold button in the center of the handle and push  
down on the handle.  
Figure 29.  
WARNING:Failure to  
follow these folding instructions  
could result in serious injury or  
death.  
Figure 30.  
CLEANING SEAT PAD  
* To clean the seat pad. use warm water, soap and a sponge, and let air  
dry.  
STOP  
IF YOU EXPERIENCE ANY DIFFICULTY IN USING THIS PRODUCT,  
PLEASE CONTACT OUR CUSTOMER SERVICE DEPARTMENT AT (800) 328-7363  
BETWEEN THE HOURS OF 8:00AM AND 4:30PM PACIFIC COAST TIME FOR ASSISTANCE.  
9
 

3M Cordless Sander 20230 User Manual
Abocom Network Card WUB1600 User Manual
ADC Network Card ComProtect User Manual
Agilent Technologies Cable Box 8590 User Manual
Agilent Technologies Weather Radio 81630B User Manual
Aico Smoke Alarm RFD User Manual
Air King Portable Multimedia Player 3C614C User Manual
American Power Conversion Switch MasterSwitch User Manual
Audiovox Automobile Alarm IMO 720 User Manual
Audiovox Remote Starter APS 510a User Manual