tEnt sEtup instructiOns
MODEL 2000008916
Before you begin
Connect Leg Poles
• Read all instructions before set up.
• Select a level site clear of rocks, branches, and other hard or
sharp objects, to install your tent.
WARNING: Keep clear of overhead power lines.
• Do not set up your tent under trees because of potential lightning
strikes or falling tree limbs in inclement weather.
• Secure with all stakes and guylines provided to prevent property
damage or personal injury.
• Insert top poles and leg poles into pole connectors.
(Fig. 3, Fig. 4 and 5)
2
• Insert the pin into each leg pole. (Fig. 6)
Pole Connector
• For best results in windy conditions, position narrow end of tent
into the wind.
• Enlist the help of at least one other person to assist you when it
is time to assemble the tent.
pole Descriptions
Top Pole
Leg Pole
Description
Qty.
pole
pole
no.
repair Kit replacement Kit
Main Roof Pole, grey
Side Roof Pole, black
Side Roof Pole, black w/Yellow mark
Front & Rear Roof Pole, black w/Green mark
Center Steel Leg Pole w/ red mark
Side Steel Leg Pole
2
2
2
2
4
4
5010000549
5010000549
5010000548
5010000548
5010000753
5010000761
1
2
3
4
5
6
5010000539
5010000539
5010000540
5010000540
N/A
Fig. 5
Fig. 4
N/A
Layout & Positioning
of Tent and Poles
1
• Layout and position the tent with door facing desired
direction. (Fig. 1)
• Stake down tent corners first through the stake rings. (Fig. 2)
• Keep the floor taut.
5
6
6
Fig. 3
• Stake down the remainder of the stake rings.
• Assemble all poles by unfolding and interlocking the shock-
corded pole sections.
Leg
Pole
• Insert the body poles into the pole sleeves.
Pin
4
1
Clip
Fig. 6
Fig. 7
2
Attach Tent to Leg Poles
Using Clips
3
4
• Attach clips along the edges of tent to leg poles. (Fig. 7)
• Make any adjustments to the tent stakes, if needed.
Fig. 1
3
Pole
Sleeve
Attach Rainfly
• Drape rainfly over tent. (Fig. 8 and 9)
• Connect the elastic loops with “S” hooks to the leg
poles. (Fig. 10)
Tent Stake
• Secure rainfly with straps located on the underside of
rainfly. (Fig. 11)
• Attach and stake out guylines. (Fig. 9)
HINT: During setup, keep door zipped to keep proper
tension on fabric.
Stake Ring
(Continued on other side)
Fig. 2
|