TENT SETUP INSTRUCTIONS
MODEL 2000007832
Before you begin
tꢀ Read all instructions before set up.
tꢀ Select a level site clear of rocks, branches, and other hard or
sharp objects, to install your tent.
WARNING: Keep clear of overhead power lines.
tꢀ Do not set up your tent under trees because of potential lightning
strikes or falling tree limbs in inclement weather.
tꢀ Secure with all stakes and guylines provided to prevent property
damage or personal injury.
tꢀ For best results in windy conditions, position narrow end of tent
into the wind.
tꢀ Do not drop tent.
tꢀ Do not bounce tent bag on its end to remove tent, as these
actions may damage the frame.
Fig. 6
tꢀ THIS RECREATIONAL PRODUCT REQUIRES A MINIMUM OF TWO
PEOPLE TO ASSEMBLE.
tꢀ Under no circumstances should this product be used to cover
automobiles, marine products or similar items.
CAUTION: Avoid pinch points when opening and closing the
tent frame.
Extend the Tent Frame
tꢀStand the tent upright with the hub assembly at the
1
top. (Fig. 1)
tꢀUnfold the arms of the tent downward until they lay flat on
the ground. (Fig. 2)
Fig. 5
Verify Connections
between Tent and
Frame Poles
3
tꢀ Verify the clips along the edges of the tent are properly
attached to the frame poles. (Fig. 7 and Fig. 8)
Fig. 2
Fig. 1
Raise the Tent
tꢀ Unfold the arm joints located at each of the tent corners.
The tent will raise as the leg poles are extended.
(Fig. 3 and 4)
tꢀ Extend each of the telescoping leg poles until they snap
into place. (Fig. 5 and 6)
2
Fig. 7
Pole
Clip
Fig. 4
Fig. 8
Fig. 3
(continued on other side)
|