Installation Instructions
NZ, AU Installation Information
BI452 series
Built-In Compact
Oven
BI602 series
Built-In Oven
BI602CTE series
Built-In Oven/Cooktop combination
BI602ED series
Built-In Double
Oven
BI602XC series
Built-In Oven/
Microwave
combination
541768C 10.2004 NZ
Installation Instructions
Installation instructions
Check that the oven cavity is square
and within the limits in the installation
dimensions.
Flush fitting installation options
1
a
2
3
Remove the mains wiring access cover.
Connect the mains wiring and replace the
access cover.
20 mm
2.5 mm
4
Remove the oven door and accessories, lift
and slide oven into place. When installing
the oven it is essential to centre the product
in the cavity giving a spacing of 2.5mm from
the door edge to the joinery
b
5
6
Secure oven in cavity using the four ‘wood
screws’ and washers supplied through the
enamelled frame at either side of the oven as
shown in the flush fitting installation options.
20 mm
Test then refit the door and accessories,
check that the oven is firmly secured in the
kitchen unit.
2.5 mm
CUPBOARD FRONT
c
Installing a cooktop above an oven
If installing a cooktop above the oven ensure
adequate clearance is provided for the
cooktop as per the Cooktop Manufacturers
Instructions.
20 mm
2.5 mm
DRAWER FRONT
2
Height recommendation guide
Figures are based on an average height of 1650mm (5’5”) wearing shoes. The height of the
product may vary according to the height of the most frequent user.
3
BI602 series Single Built-In Oven
BI602ED series Double Built-In Oven
Top View
Top View
20 mm
20 mm
16-20 mm
16-20 mm
600 mm
600 mm
4
BI602CTE series Built-In Oven/Cooktop
Combination
Benchtop Detail
Benchtop
55 mm
MIN.
20 mm
Gap
CookTop Cutout*
15 mm
MIN.
OVEN
*see cooktop installation
instructions p/n 599100
Cooktop Installation
1
2
Remove the brackets from the cooktop.
Place the cooktop in the cutout and secure
using the brackets previously removed.
3
4
5
Feed the cooktop wiring harness out
through the oven cavity.
Remove the oven connector block cover on
the oven top wiring cover.
Connect the cooktop wiring harness lining
the numbers/letters on the harness with
the numbers/letters on the oven connector
block. Leave plastic wiring card attached for
future reference.
6
Clamp the wiring harness with the wiring
clamp on the oven top wiring cover.
7
8
Replace the oven connector block cover.
Install the oven as described on page 2.
Top View
harness detail
oven connector
block
plastic
wiring card
5
4
P
20 mm
N
E
E
N
3
2
1
16-20 mm
600 mm
5
BI452 series Compact Built-In Oven
BI602XC series Built-In Oven/Microwave
Combination
70 mm min.
clearance
Top View
Top View
20 mm
20 mm
16-20 mm
16-20 mm
600 mm
600 mm
6
|